 |
|
 |
Remotely Control Icom Transceivers through an IP Network
- The RS-BA1 allows you to use the radio installed in another room using your home network or even from a remote location over the Internet.
- Low voice latency
Advanced Remote Control Interface Tailored to Icom Transceivers
- Most functions and modes of your transceiver, including interference rejection functions and IF filter settings, can be controlled. Also, S-meter and SWR can be observed.
- Rx Voice recording function.
The RS-BA1 consists with two component software applications; System configuration software and remote control software. The system configuration software sets up IP address, audio sampling rate and other settings. The remote control software provides a user interface, similar to the radio's front panel, and allows you to control the radio from a remote location.
The IC-7600, IC-7410, IC-7200 or IC-9100 can be connected to a PC with a USB cable and the input/output audio signal and CI-V command is sent through the USB cable.
The IC-7800 or IC-7700 can be connected to a PC with a RS-232C cable plus S/P DIF or ACC cable. *
The IC-756PROIII, IC-746PRO, IC-7400 or IC-7000 can be connected to a PC with an audio cable and RS-232C cable through CT-17 CI-V level converter.*
*RS-BA1 operation with the Base station’s PC connected to the radio’s ACC socket, MIC connector, or S/P DIF jack for audio communication cannot be guaranteed.*Depending on your radio, a few functions or modes cannot be used, or you need to update the radio’s firmware to operate the CW keyer, using the RS-BA1.
Supplied items
- CD (including the RS-BA1 instruction manual, the RS-BA1 installer, the USB driver and the USB driver installation guide)
- USB cable (A-B type)
- Installation guides
All stated features, appearances, screen shots, and specifications may be subject to change without notice.